How To Use BORPower®
 
INSTALLATION INSTRUCTIONS
 

Users of BORPower® are advised to follow the following step when installing the product:

  1. Renew the motor oil and the oil filter.

  2. After completing the oil change, start the engine and warm it up till operating temperature is reached.

  3. Warm the BORPower bottle up to appr. 70-80 degrees celcius for ex in hot water, after that shake the BORPower® bottle well for at least 3 minutes to make sure that the nano-particles dispense properly.

  4. For best effect you can rinse the bottle with FAST evaporating brake cleaner and shake it, and then add the rest into the engine. The brake cleaner will evaporate it self and leave no residues.

  5. After application, drive the vehicle for at least 25 km (16 miles) or let the engine run for 20 - 25 minutes.

  6. BORPower® takes several hours of driving time after application to become effective to its full extent.

  7. For car, BORPower® lasts for a mileage of 60,000 km (40,000 miles) after application. This also holds if the motor oil and/or the oil filter arereplaced earlier.

 
IMPORTANT NOTICE
 

Please note the following below applying BORPower®:

  1. BORPower® is applicable to petrol, diesel and LPG 4-stroke engines (NOT 2-stroke engines with which most of the Motorcycles apply) as long as they are satisfied with the common ACEA and API standards.

  2. We take no responsibility for motor damage due to the incorrect application of BORPower®.

 
 
bor power